Review of Redarc Battery Charger - Smart Start Load Disconnect Manager30, BCDC - 331-SBI12-LLD скачать в хорошем качестве

Review of Redarc Battery Charger - Smart Start Load Disconnect Manager30, BCDC - 331-SBI12-LLD

Click for more info and reviews of this Redarc Battery Charger: https://www.etrailer.com/Battery-Char... Check out some similar Battery Charger options: https://www.etrailer.com/dept-pg-Batt... https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-Demo-Reda... Hi everybody. Andy here with etrailer.com. And today we're gonna take a look at this Redarc Smart Start Load Disconnect for the Manager 30 or BCDC with lithium battery. Now this Load Disconnect Isolator is designed to be used with your lithium iron phosphate batteries, and it connect to your Readarc Manager 30 battery management system, or your BCDC battery charger to protect your auxiliary battery from excessive discharge. Now, this is for use with your Redarc Manager30 battery management system model number 331-BMS1230S2-NA or your BCDC battery charger model numbers 331-BCDC1225D or 331-BCDC1240D. This monitors your auxiliary battery to ensure that the voltage stays within the limits, set on your Manager30, and the voltage spike protection reduces the risk of damage to the Manager30, the BCDC, and other equipment. It will disconnect the load by opening the solenoid in the, if the voltage drops below the turnoff setting will also trigger the solenoid to close again, when voltage reaches turn on level. The built in time delay reduces the chance of the solenoid chatter and this over this blue override wire that you see right here allows for simple fault detection. All you need to do is just connect this to an LED which is not included. And that can be mounted in your cab for easy viewing of diagnostics. This is suitable from marine applications, and the overmold design prevents vibration of the internal components. The maximum continuous current is a hundred amps, and the standby current is gonna be less than five milliamps. And the output connection is 12 volt DC. Now, just to give you some overall dimensions, looking first at the height, and I'm gonna be including the terminals here, we are gonna be sitting right at about three and a quarter inches tall, then measuring the width. I'm gonna be measuring at the widest point here, where you would mount the mounting brackets or the mounting plates or the overall width, we're gonna be sitting right at about two and almost three inches. I'm gonna call it at two and 15, 16 inches, and then looking at the depth, we're gonna be sitting pretty close to two and a half inches with the overall depth. Now this will include instructions as you see right here, and that's gonna conclude our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me..