Setup your Raspberry Pi as wireless access point (Update!) скачать в хорошем качестве

Setup your Raspberry Pi as wireless access point (Update!)

Hello guys, in this video I am going to show you how to set up your Raspberry Pi as a wireless access point. I hope you enjoy the video, if you have any question or feedback, please leave a comment down below. ⌚️Timestamps: 0:00 | Introduction 0:55 | Installing the software 2:31 | Setting a static IP address 3:27 | Enabling the routing 3:45 | Firewall rule 4:23 | Configuring the DNSmasq 5:24 | Unblocking the wifi 5:33 | Configuring the Hostapd 7:03 | Testing the access point 7:38 | Thank you 💻The commands and settings used in the video: sudo apt update sudo apt upgrade sudo apt install hostapd sudo systemctl unmask hostapd sudo systemctl enable hostapd sudo apt install dnsmasq sudo DEBIAN_FRONTEND=noninteractive apt install -y netfilter-persistent iptables-persistent sudo nano /etc/dhcpcd.conf interface wlan0 static ip_address=192.168.4.1/24 nohook wpa_supplicant sudo nano /etc/sysctl.d/routed-ap.conf net.ipv4.ip_forward=1 sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE sudo netfilter-persistent save sudo mv /etc/dnsmasq.conf /etc/dnsmasq.conf.old sudo nano /etc/dnsmasq.conf interface=wlan0 dhcp-range=192.168.4.2,192.168.4.20,255.255.255.0,24h domain=wlan sudo rfkill unblock wlan sudo nano /etc/hostapd/hostapd.conf #Access point with password (WPA2): country_code=GB interface=wlan0 ssid=YourNetworkName hw_mode=g channel=7 macaddr_acl=0 auth_algs=1 ignore_broadcast_ssid=0 wpa=2 wpa_passphrase=YourPassword wpa_key_mgmt=WPA-PSK wpa_pairwise=TKIP rsn_pairwise=CCMP Check your country code: localectl status If you want your access point to be open(no password): interface=wlan0 driver=nl80211 ssid=YourNetworkName hw_mode=g channel=6 sudo reboot 🎵Music by: "Sappheiros - Dawn" is under a Creative Commons license (CC BY 3.0) Music promoted by BreakingCopyright: http://bit.ly/2OBe00v