VPC MongoosT-50CM2 Base - Change and adjust springs tutorial скачать в хорошем качестве

VPC MongoosT-50CM2 Base - Change and adjust springs tutorial

How to change the springs in the new Virpil VPC MongoosT-50CM2 Base NOTE: If you have difficulty re-inserting the spring tension screws, the receptical that the screw attaches to might have moved position, just remove the 4 screws holding the bottom plate on to gain access to the receptical and turn it to allow the screw to enter it. The tighten up the spring tension screw. #01: Downloading and installing the Virpil software tutorial    • OUTDATED: see link below - Downloading and...   #02: Update Throttle firmware and calibration    • Set-up and configure Virpil throttle tutor...   #03: Update Joystick firmware and calibration    • Set-up and configure Virpil joystick tutor...   #04: Attach grip to Joystick    • Virpil Deskmount / Attach warbrd base and ...   #05: Virpil - config software - Basic usage    • Using Virpil VPC configuration software   #06: Virpil - configuring Throttle toggle switches    • Virpil VPC configuration software - thrott...   #07: Virpil - configuring Axis tutorial    • Virpil VPC configuration software - axis t...   #08: Virpil - configuring mode selector with Joystick Gremlin    • Virpil - configuring using Joystick Gremlin   #09: Virpil - configuring shift states    • Virpil VPC Joystick - configuring shift st...   #10: Virpil - configuring Axis Zoom    • Virpil VPC Joystick - configuring Axis Zoo...   #11: Installing Vjoy and Joystick Gremlin    • Installing Vjoy / Joystick Gremlin - Tutorial   #12: Virpil - configuring rotaries using Joystick Gremlin    • Virpil VPC Throttle - Macros, rotaries Tut...   #13: Virpil - configuring buttons/ Encoders    • VPC Virpil software tutorial - Button conf...   #14: Virpil - CM2 Base Change Springs    • VPC MongoosT-50CM2 Base - Change and adjus...   #15: Virpil - CM2 Base Change CAM's    • VPC MongoosT-50CM2 Base - Change CAMs tuto...