How To Clean A Nitro RC Car скачать в хорошем качестве

How To Clean A Nitro RC Car

History of WD-40    • History of WD-40 | Who Invented It? (1.1)   0:00 Prep for Wash 0:29 Blow off 0:48 Scrub with Simple Green 1:15 Rinse 1:40 Dry 2:00 Spray with WD40 (Water Displacement, 40th formula) 2:29 Blow off the excess WD40 2:51 Lube Ball Joints, tie rod ends, etc 3:04 Dry electronics compartment, Dry terminals 3:11 Make sure the electronics still work 3:18 Reassemble Cleaning this RC car because it had dirt from it being ran in 2008 or 2009 and had been in storage with dirt and mud since then. Needless to say it had a considerably amount of oil, fuel, dirt, and sand from the middle east packed onto it. Simple green made this job easy. 1) Plug all the holes, Intake, exhaust, make sure the fill for the tank stays closed. For this I used some Vinyl Tube End Caps. I used a 3/8" one for the exhaust, the intake cap was a plastic one I had laying around, but a 1/2 or 5/8 vinyl cap should work. Assorted cap set from Amazon. Affiliate link https://amzn.to/2Gi48KK 5/8" Cap from Amazon. Affiliate link https://amzn.to/2SaGtyq 2) Remove the Wheels. Most wheels have foam inserts in them. We do not want the foam in the wheels to get wet. 3) Blow it off with compressed air. This gets the loose stuff and parts off the car. It also helps the Simple Green to penetrate down through the dirt. 4)Spray it down with Simple Green and Scrub with a short brush, tooth brush, potato brush 5) Rinse it off with a soft stream of water. DO NOT BLAST IT 6) Since the plastics will not be super shiny like they were new. Give the car a light misting of WD-40 and blow off. Maxima SC1 or GT85 can also be used to bring the luster back to the plastic parts.