“Caliburn G3 Pro Unboxing ✨ Next-Level Display Read more in the discprition…! скачать в хорошем качестве

“Caliburn G3 Pro Unboxing ✨ Next-Level Display Read more in the discprition…!

The Caliburn G3 Pro is a pod system device with the following key features: • Battery & Power  • Integrated 1000 mAh rechargeable battery   • Maximum output: 35 W  • Pod / Coil / E-Liquid Capacity  • Uses pods with a 3 mL e-liquid capacity (for the 0.4 Ω pods)   • Compatible resistance range: ~ 0.4 Ω to ~ 0.9 Ω  • Display & Interface  • Features a full screen / LCD display showing vaping details (battery, wattage, etc.)   • Offers both button firing and air-activation modes  • Physical Dimensions & Build  • Dimensions: approx 123.5 × 27.8 × 16.8 mm   • Net weight: ~ 92 g   • Body materials: Zinc-alloy (or metal body) with plastic / PCTG for pods  • Charging & Other  • USB-C fast charging (2 A support)   • Modes & locking: You can switch between button and air modes, and lock the fire button. (Double-press toggle)  ⸻ 🛠️ How to Use the Caliburn G3 Pro Here’s a step-by-step general guide (based on the user manual / typical procedure). Always refer to the official manual for safety and specifics.  1. Unbox & Inspect  Take out the device, pod(s), USB-C cable, and any accessories. Make sure everything is in good condition. 2. Install Pod & Fill E-Liquid  - Remove the pod from the device (usually by magnetic pull or slot).  - Locate the fill port (often a silicone plug or flap).  - Fill the pod with your e-liquid (be careful not to overfill).  - Replace the seal / plug, ensuring it is closed properly.  - Let the pod sit for a few minutes (5–10 mins) to allow the coil to prime (wicking). 3. Insert the Pod  Push the pod back into the device; it should click or magnetically snap in place. 4. Power On / Off  Usually pressing the fire button 5 times rapidly toggles power on/off (common in Uwell devices)  5. Mode Selection & Lock / Toggle  - To switch between button mode and air-activation mode, press the fire button twice within 2 seconds.   - You can lock or unlock the button ignition in that same way (double-press).  6. Adjust Wattage / Settings (if applicable)  Use the interface on the display or control buttons (if present) to raise or lower wattage up to max (35 W).  Check your pod’s resistance and choose a setting appropriate for it. 7. Vape / Draw  - In button mode, hold down the fire button while inhaling.  - In air mode, just inhale and the device will trigger automatically. 8. Charging  When battery gets low, plug in via USB-C. The display usually shows charging progress. Avoid overcharging and always use suitable cables/chargers. 9. Maintenance & Safety  - Replace pods/coils when flavor degrades or you get dry hits.  - Clean connections and make sure nothing is leaking.  - Do not overfill, avoid chain vaping beyond device limits, and always follow safety instructions in the manual. #abrixcloud #vape #pod #Abrix #eliqiud #newpod #vapesmoke