Tips to Get Thicker Snow Foam and Mistakes to Avoid скачать в хорошем качестве

Tips to Get Thicker Snow Foam and Mistakes to Avoid

In this video I’ll be talking about some common reasons why your snow foam lance may not be producing the foam thickness you’re looking for and how to get better quality snow foam. I’m a believer that thick snow foam doesn’t equal effective snow foam, and cleaning power is more important to me than my car looking like it’s covered in shaving foam! Some snow foams are designed to produce thicker foam than others and as long as they do a good job of cleaning, the thickness doesn’t bother me. However, if your snow foam is so thin it looks like skimmed milk and it has dripped onto the floor completely about a minute after being applied, then something’s probably amiss and hopefully these tips will be helpful to correct the problem! If you’re looking for some snow foam recommendations, then check out my comparison video:    • The Best Snow Foam? Comparison with Bilt H...   Here are the links to the products and tools used in the video. Some of the links are affiliate links to In2Detailing so if you make a purchase after clicking the link, then I may receive a commission at no additional cost to you. MJJC Foam Cannon Pro: https://www.in2detailing.co.uk/produc... Wax Planet 8 Below: https://www.in2detailing.co.uk/produc... Autobrite Magifoam: https://www.in2detailing.co.uk/produc... Garage Therapy Snow Foam: https://www.in2detailing.co.uk/produc... EZ Meltdown: https://www.ezcarcare.co.uk/products/... Here is some more info about the snow foams and pressure washers being used at various points in the video. All the clips were filmed using the MJJC Foam Cannon Pro on the maximum setting. • EZ Meltdown (1:10) with Karcher K2 and 1.25 mm orifice at 0:05 and 0:32 • Wax Planet 8 Below (1:15) with Karcher K4 with 1.1/ 1.25 mm orifice at 2:27 • Car Chem Pre-Soak Plus (1:10) with Karcher K2 and 1.25 mm orifice at 3:10, 6:40, 7:35 • Wax Planet 8 Below (1:10) with Karcher K4 and 1.25 mm orifice at 5:00 • Autobrite Magifoam (1:20) with Karcher K4 and various foam cannons (1.25 mm orifice for non-Karcher cannons) at 6:00 • Bilt Hamber Touch-Less (1:3) with Karcher K4 and 1.25 mm orifice at 6:57 Follow me on Instagram!   / autocarehq   Thanks for watching! Time Stamps: 0:00 Struggling to Get Thick Foam? 0:43 Flow Rate 1:13 Orifice Sizes 2:31 Keeping the Lance in Good Condition 3:09 Service the Foam Cannon 3:48 Does Warm Water Help? 4:41 Cheap vs Expensive Lances 5:39 Is Thicker Foam Better?