Erica Synths Noise Generation with Black VCO, Modulator, Polyvoks VCF, Octasource, and Delay Modules скачать в хорошем качестве

Erica Synths Noise Generation with Black VCO, Modulator, Polyvoks VCF, Octasource, and Delay Modules

The audio is originating from the S&H circuit of the Black Modulator. Its CV is being driven by the Black VCO's Saw wave output, which is, in turn, being pitched (using the 1V/oct CV) by the Saw output from the Modulator, running at audio rate. The sweeping pitches of the main oscillator are essentially being bit-crushed by the S&H, the rate of which is controlled by the LFO. So there is a type of feedback here: as I increase the frequency of the modulator, it drives the pitch of the oscillator higher, while increasing the sampling rate of its very own pitch. Note: I'm not using any noise sources. This audio output is low-pass filtered via Polyvoks VCF, the frequency of which is modulated by the Octasource. The latter is also changing the time on the Black Stereo Delay module and panning the channel of the output. A little more Ableton reverb is added to sweeten the jam. In the video, I play with the pitch of the VCO and LFO, adjust the cut off frequency on the VCF, and the rate of the Octasource, while adjusting delay's input level, dry/wet mix, and the feedback. I hope you enjoy a little bit of noise in your life. More on the various Erica Synths modules used in this video here: https://www.ericasynths.lv/modules