FrSky ETHOS 1.6.2 Program XACT Servo Direct From Radio S.Port Connector via FBUS with Device Config скачать в хорошем качестве

FrSky ETHOS 1.6.2 Program XACT Servo Direct From Radio S.Port Connector via FBUS with Device Config

Just a short video to show the new feature in ETHOS 1.6.2 for programming the XACT servos direct from the radio S.Port Connector Plug the servo into the 3pin connector on top of the radio, with the signal wire toward the notch side. Then, go to System - Device Config - Servos - XACT and set the "Module" option at the top to S.Port Connector P1/P2: Strength of locking servo arm P3(D1 in ETHOS):Friction P4(D2 in ETHOS):Filter P5(Gap in ETHOS): Electronic Slop If the parameters are still greyed out, you may need to update the servo firmware to the latest available from the product page of the matching servo model. Be sure to pay attention when you flash the BLS series servos that you do not flash them with the HV series servo firmware as that will brick them and require them to be sent to FrSky service center for recovery. https://www.frsky-rc.com/product-cate... BLS54xx : https://www.frsky-rc.com/product/bls5... https://www.frsky-rc.com/product-cate... HV54xx : https://www.frsky-rc.com/product/hv54...