Bombatura del fondo - Lavorazione a rasiera parte quarta : finitura finale della superficie скачать в хорошем качестве

Bombatura del fondo - Lavorazione a rasiera parte quarta : finitura finale della superficie

Conclusione della lavorazione a rasiera e finitura della superficie ENGLISH TRANSLATION of written notes in the video, in order of appearance : 00:05 - Back arching - Scraper working part four : final finish of the surface 00:20 - Redraw for the last time the contour lines, taking care to stay light with the signs of the pencil to not dig in the surface 00:59 - Check the shape of the fifths using the shadow cast by a ruler, also observing the changes of the curves during movement 01:21 - Use the oblique light to identify the areas to be retouched, highlighting them with pencil marks 01:38 - Start scraping putting more emphasis in the marked areas, to correct the last differences in shape and symmetry 02:06 - Progressively extend the finish to all the rest of the arching, using always the same pressure of the scraper to make uniform the relationship between cutting and compression over the entire surface 02:21 - Always keep the cutting edge angled with respect to the grain and flame of the wood, trying to get a smooth surface and without humps, of uniform color and brightness 02:32 - Make repeated passes very light and fast covering small areas at a time, observing changes in the color, brightness and brilliance of the figures of wood to understand the better directions and angles of cut 10:26 - Observe the transverse lines formed by the flames, using them as indicative reference of the curves, making them continuous and flowing eliminating any angularity 11:54 - Making the latest passes using the lowest possible pressure, leaning well on ring and little fingers to hold the scraper almost relieved from wood trying to remove the surface "hair" only 13:46 - Make a final check of the Sixth heights and arching shapes, making sure that the finish is of satisfactory quality, no scratches or irregularities on the surface, observing it carefully with very oblique light 14:34 - Make a final finish rubbing (burnishing) vigorously the surface with absorbent kitchen paper (cellulose fibers) to further increase the brightness of the wood 15:20 - For more information about the use and sharpening of scrapers refer to the previous videos "Back arching - Scraper working part one", "part two" and "part three" Index of videos : www.davidesora.altervista.org/videos/