DesignJet 1050 & DesignJet 1055 load media roll - HP Plotter | 01256 783390 скачать в хорошем качестве

DesignJet 1050 & DesignJet 1055 load media roll - HP Plotter | 01256 783390

How to load a media roll on a DesignJet 1050 & DesignJet 1055 series plotter. For Sales, Repairs, Service, Parts, Support & More visit: http://www.hpplotter.co.uk or Email [email protected] / Tel 01256 783390 This video shows how to load a paper roll on the Designjet 1050c Series (including 1050c plus/1055cm/1055cm plus). On the video you are shown a schematic normally stuck onto the machine front telling you the correct way round to load the roll on the spindle into the machine. The operator demonstrates how to first put the paper roll onto the spindle without allowing it to drop onto the cap end and damage it. The easy way to initialise the panel is to lift the pinch lever and the panel will then instruct the operator to align the paper and feed it into the machine on the receiving roller until the sensor beeps, then close the pinch lever. The Designjet will drag the roll in, make sure it is square, if not it will roll it out and start again, and when it is fully aligned it will trim the edge and the roll will have been successfully loaded ready to print.