Igniter Testing with QuickDip Pyrogen скачать в хорошем качестве

Igniter Testing with QuickDip Pyrogen

My QuickDip pyrogen (QuickBurst) came in the mail this weekend, so I wanted to try out a few configurations for later airstarting Aerotech motors. The final 3 igniters are inside of a small cardboard tube that I coated the inside with QuickDip to simulate "painting" the upper grain with the pyrogen. Ematches are ones I purchased on eBay. 1. Commercially-supplied igniter for Aerotech H73J - 12.9V power supply 2. 30cm ematch (6V power supply, all subsequent igniters are also fired with this power supply, i.e. an Estes launch controller) 3. 1m ematch 4. 30cm ematch dipped in QuickDip 5. 1m ematch with only the base brushed in QuickDip 6. 30cm ematch in a cardboard tube coated inside with QuickDip 7. 1m ematch in a cardboard tube coated inside with QuickDip 8. 1m ematch with base brushed in QuickDip in a cardboard tube coated inside with QuickDip. The reason the 1m ematches only had the base brushed is that for my upcoming 2-stage flight, the H73J nozzle throat is too small for a larger ematch head.