Canon printer p03 G2010 G3010 G3012 Paper Pickup Assembly & waste inkpad Replace скачать в хорошем качестве

Canon printer p03 G2010 G3010 G3012 Paper Pickup Assembly & waste inkpad Replace

Canon G2010 Paper Jam Nightmare? FIX IT NOW! Canon G2010 Paper Jam - Easy Solution! Canon G2010 Printer Paper Jam - Quick Fix (2025) Paper Jammed G2010? Here's the fix! How to replace pickup assembly and waste inkpad canon inkjet printer canon g3000 orange light flashing canon g3000 printer orange light blinking canon g3010 error code e03 canon g3010 error code p03 canon g3010 reset canon g3010 light blinking problem canon g3010 canon printer paper not pickup canon g3010 pickup assembly change Step 1: Turn Off and Unplug the Printer Before you begin, make sure the printer is off and unplugged to avoid any risk of electric shock or injury. Step 2: Open the Printer Cover Lift the printer cover to expose the internal components. This will allow you to access the paper feed mechanisms and the rollers. Step 3: Locate the Paper Pickup Assembly The paper pickup roller is located near the input tray. The roller is responsible for pulling paper into the printer. Look for any visible parts that need replacing. Often, you’ll see the paper pickup roller and separator pad easily once the cover is open. Step 4: Remove the Old Paper Pickup Roller The roller is typically attached to a shaft. You may need to slide it off or use a small screwdriver to gently pry it off. Be careful not to damage surrounding parts while removing the roller. Step 5: Replace the Paper Pickup Roller Take the new roller and carefully slide it onto the shaft where the old roller was located. Make sure it is seated properly. If the new roller requires any sort of locking mechanism, ensure it is correctly engaged. Step 6: Replace the Separator Pad (if needed) The separator pad helps prevent multiple sheets of paper from being pulled through at once. It may need to be replaced if it's worn out. Locate the separator pad near the pickup roller. It may be attached with clips or screws. Gently remove the old separator pad and replace it with a new one. Ensure it's positioned correctly to make sure the paper feeds correctly. Step 7: Reassemble the Printer After replacing the roller and separator pad, reassemble any parts you’ve removed. Close the printer cover, making sure everything is secure. Step 8: Test the Printer Plug the printer back in and power it on. Load a few sheets of paper into the input tray and try printing a test page. Check for any errors or paper feed issues. Step 9: Adjust Settings (if necessary) If you continue to have paper feed problems, you might need to clean the rollers with a damp cloth or check for any misalignment in the parts.