Скачать с ютуб OPNSense Failover from AT&T BGW210-700 Broadband Gateway to NETGEAR LM1200 4G LTE (Cellular) Modem в хорошем качестве

OPNSense Failover from AT&T BGW210-700 Broadband Gateway to NETGEAR LM1200 4G LTE (Cellular) Modem

I have put together this video to walk you through my process for setting up a Cellular Modem failover system using an OPNSense router on an AT&T broadband LAN. Note that we are basically adding a cellular WAN gateway to an internal LAN, and using that as a backup WAN gateway when the primary gateway connection goes down. While I am specifically using the AT&T BGW210-700 modem/router (“gateway”) and the Netgear LM1200 LTE Modem https://amzn.to/3TubI6e, this should work with any broadband service, OPNSense router and cellular modem. This tutorial assumes your OPNSense router is already installed and routing your network. VIDEO CHAPTERS 00:00 Introduction 02:38 Install SIM Card 02:54 Initial Configuration of LM1200 Cellular Modem 09:27 Add Cellular Modem as Gateway 10:55 Configure Failover 12:42 1.Add monitor IPs to the gateways 14:06 2.Add Gateway Group 17:01 3.Configure DNS for each gateway 18:46 4.Policy based routing 20:36 5.Add allow rule for DNS traffic Here are some resources: NETGEAR LM1200 4G LTE Modem USE LTE as a Primary or Backup Internet Connection:    • NETGEAR LM1200 4G LTE Modem    USE LT...   OPNSense Multi WAN Failover: https://docs.opnsense.org/manual/how-... OPNSense Firewall Multi-WAN Failover and Load Balancing - Virtual Lab Building Series: Ep 6:    • OPNSense Firewall Multi-WAN Failover ...   How to Use Your Own Router with AT&T Fiber Internet | 2020 Update with BGW210-700:    • How to Use Your Own Router with AT&T ...   NETGEAR 4G LTE Broadband Modem (LM1200): https://amzn.to/47rYP2N Good luck!