STEK PPF DIY KIT - Door Edge Guard TPU Tape (0.47 in. x 196.85 in) Installation Guide скачать в хорошем качестве

STEK PPF DIY KIT - Door Edge Guard TPU Tape (0.47 in. x 196.85 in) Installation Guide

☑️Buy this product - https://www.amazon.com/STEK-Protectio... ☑️Features Protects original paintwork against dings and light scratches. Self-healing technology built into the film guarantees scratch resistance. The film’s multiple layers work together to heal any surface-level damage and scratches. Protects vehicle door edges from nicks, chips, and scratches. Fits most vehicles with a pull-out handle design. Easy to install and remove without any residue. ☑️Preparation Prepare the surface by cleaning the application area thoroughly with isopropyl alcohol to ensure the cleanest surface possible. Be sure to remove all contaminants. ☑️Installation 1. Cut a piece of film into your desired length. 2. Peel the release liner (bottom layer the opaque layer) from the film. 3. Align the film with the door edge, making sure that the film is as tight as possible against the application area. Leave part of the film hanging over the surface. During installation, this part can be applied over the edge for better adhesion (Note: Do not leave too much slack on the inside of the door as it will only adhere to smooth surfaces). 4. Remove the cap sheet (top transparent layer of the film) that protects the film. If you see the edge lift upon the removal of the cap sheet, use your fingers and push down the edges. 5. Apply the film by pressing it firmly down onto the surface. Use a plastic card or small squeegee to press down and remove any remaining bubbles.