scuf envision pro fix broken bumper lb rb replacement fix скачать в хорошем качестве

scuf envision pro fix broken bumper lb rb replacement fix

The SCUF Envision Bumper LB / RB of the OEM company is built to fail. It will eventually break on you. The thin plastic connecting the bumper to the paddle will snap and break off. It does not matter if you replace it with another OEM part (by sending it in for repair or replacing it yourself). It will break again. There is a weak part in the construction of the current SCUF Envision PRO Bumper LB RB. Only until that geometry is corrected will the OEM part succeed. Otherwise, it will fail after a certain number of presses. gtx-envision-bumper: https://www.gadgetronx.com/r?cs_r=jP8y7z The bumper in this video will NOT fail. If the SCUF Envision PRO bumper in this video is used as a replacement part for the original SCUF Envision PRO Bumper LB / RB. The SCUF Envision bumper in this video removes the obsolescence from the SCUF Envision PRO Bumper (as seen). It has metal pins that allow the bumper to pivot on an axis. Therefore, you can flex the bumper until eternity and in theory the bumper should NOT break, crack, split, or snap. Another strong note about the replacement SCUF Envision bumper in this video is that the plastic is thicker. The geometric design is stronger. This video and the part were produced in hopes that the OEM would correct the flawed problem in the existing SCUF Envision PRO bumper. To fix a broken LB or RB bumper on a SCUF Envision Pro controller, you'll need to carefully disassemble the controller, remove the broken bumper, and replace it with a new one seen in this video. To change the bumper: QUICK VERSION: Remove the face plate, remove the two screws that secure the bumper & replace the broken with the bumper you see in this video. LONG VERSION: Remove the faceplate, accessing the internal components, detaching the old bumper, and then attaching the new one in its place, ensuring proper alignment and connection. Key steps: Gather tools: You'll need a small screwdriver set, possibly a plastic opening tool to pry open the faceplate gently, and a new replacement bumper that you see in this video. If you bumper does not look like this video, it will break again and again. Thus, you have entered a subscription. Disassemble the controller: Remove the battery cover. Use a plastic opening tool to carefully pry the faceplate off, starting from the top edges. Disconnect any cables or wires that may be attached to the faceplate. Access the bumper: Locate the broken bumper (LB or RB) on the SCUF Envision controller's internal circuit board. Using a small screwdriver, remove any screws securing the bumper to the circuit board. Remove the broken bumper from SCUF Envision PRO controller: Carefully detach the old bumper from its connections on the circuit board, making sure to note how it was attached. Install the new bumper: Align the new bumper with the correct position on the circuit board. Secure the new bumper with the screws removed earlier, ensuring a tight fit. Reassemble the controller: Reattach the faceplate, ensuring proper alignment. Reconnect any wires or cables.