У нас вы можете посмотреть бесплатно HydroMagic Max Molecular Hydrogen Inhalation Machine Set Up | Hydrogen Therapy | Molecular Hydrogen или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
Setting up your HydroMagic Max Hydrogen Machine is easy when you know how! Follow the steps in the video carefully to ensure optimal functioning and optimum therapy from your powerful Cellular Vitality device. Any queries? Just ask us on +44(0)1743718324. 1) Plug in power cord to wall outlet and machine. 2) Unscrew water tank cover and remove lid. 3) Using a funnel, fill your HydroMagic max water tank 2/3 - 3/4 full (approximately 2.2 litres). Stop if display or voice prompt states water level too high. 4) Important step Keep tank cover off, place clean receptacle (eg 1 litre jug) beneath drainage port at rear of machine. Unscrew drainage cap, then remove small green drainage stopper (keeping both to hand!) Allow the water to drain from the tank, until all bubbles have passed and the water 💦 is flowing smoothly (usually just a few seconds). This step is necessary at first set-up and upon refilling after emptying for transport or deep cleaning 5) Attach the metal humidifying bottle holder to the 2 screws on the side of the machine. Tighten screws to secure it. 6) Add a small amount (below ‘max’ arrow) of water to the humidifying bottle. Then attach the machine-end of the nasal cannula to the ‘out’ port of the humidifying bottle. There are small arrows on the humidifying lid which show you the direction of airflow (i.e. IN = tubing from H2 and O2 ports and OUT = nasal cannula attachment). 7) For OxyHydrogen Therapy (recommended as standard practice), attach the short Y tube to the O oxygen and H hydrogen outlets, and the IN port of the humidifying bottle. For pure Hydrogen Therapy, attach the short straight silicone tubing to the H hydrogen outlet and IN port of the humidifying bottle. 8) Switch on the machine again and ensure there is no ‘water level low’ error message (if there is, add a little more distilled water to the tank). 9) If present, remove the white caps covering the H2 and O2 ports (no gas flow without completing this step!) 10) Use the left and right buttons to choose your desired therapy session duration and flow rate. 11) Attach the nose-end of the nasal cannula to your face, placing the nasal prongs just into your nostrils then looping the tubing around your ears; adjusting the neck toggle to secure comfortably. 12) Press the centre button to start the session, sit back, relax and enjoy the transformative cellular benefits of Molecular Hydrogen!