LS Wiring Harness Part 3 | Project Rowdy Ep015 скачать в хорошем качестве

LS Wiring Harness Part 3 | Project Rowdy Ep015

Part 3 of the LS Wiring Harness Cleanup will cover working my way through each of the bundled legs of wire and removing unwanted Sensors and their related wires. The goal is to create a Stand a Lone harness that only requires 4 wires to run the engine. There will be additional wires running to the vehicle to support additional features. Project Rowdy is a restoration on a 1979 Jeep CJ7. This LS Swap Harness is being prepared to be mated back to its original engine: 2001 Chevy Silverado 5.3L LM7 which has just undergone a full rebuild. References: Wiring Harness Research: http://www.LT1Swap.com Wiring Cleanup Procedures: To be published after revisions from this current build LS Fuse Block and Relay Diagram: http://bit.ly/LS_Harness_Diagrams PCM and Connectors Pinout Charts: http://bit.ly/PCMandConnectorTables Tools and Parts used: Qiorange 8 Pin Connector: http://amzn.to/2lNgMW8 Doorman Fuse Block: http://amzn.to/2kOBR2R e-Ting 5 Pin Relay Socket: http://amzn.to/2kOzzRk Absolute RLS125 Relays: http://amzn.to/2lNp4gR Vice Grip Wire Strippers: http://amzn.to/2lI3fie Loom Fabric Tape: http://amzn.to/2xZng69 Project Rowdy Playlist:    • Project Rowdy - Jeep Restoration   UCanDoIt2 Website: http://www.ucandoit2.club/ UCanDoIt2 Contact: [email protected] JeepForum Thread: http://www.jeepforum.com/forum/f22/pr... Facebook Page:   / projectrowdy   Music Intro: Alex Skrindo (Alive) #lsswap #lsswaptheworld #lsswapc10 #lsswapc10 #diyperformance #jeep #jeepcj