SWG 100 BIOGAS AUTO CAL скачать в хорошем качестве

SWG 100 BIOGAS AUTO CAL

As you might know, the SWG 100 biogas analyzer can be calibrated manually or automatically. Manually means, the user connects a test gas cylinder to the analyzer, goes to the calibration menu, and then calibrates the analyzer. Once completed, the test gas cylinder is removed again and stored at a safe location. Automatically means, the test gas cylinder is connected permanently to the analyzer. Via the analyzer firmware, the intervals for the calibration are defined. Now the analyzer will calibrate itself at the defined intervals. Please be aware, that this is only the basic demonstration for an analyzer with standard configuration. Some steps will be different for analyzers with different configurations, but at least you now understand the concept behind the auto-calibration menu. CHAPTERS 00:00 Introduction 00:18 SWG 100 Biogas analyzer auto-calibration 00:55 Calibration ports 01:18 A typical installation site 01:52 Swagelok fitting 02:09 PTFE hose fitting 02:45 Use a gas detector to check for leaks 02:58 Setting up auto-calibration 05:05 Typical test gas values 05:25 Saving setup values 05:42 System alarm 05:53 Disclaimer