Rex RX-607Z Problems(and potentially solutions) скачать в хорошем качестве

Rex RX-607Z Problems(and potentially solutions)

Hi there, when I received the machine(purchased from Amazon) it was running ok, pretty noisily, but as I started stitching through my sails(through 4-5 layers of Dacron sailcloth) I noticed there was quite a bit of play in the needle shaft(excessive deflection). I proceeded to take the front end apart, and found that there was a poorly machined bore in two parts, which allowed for a slight jiggle. I ordered new versions of these, however now the problems are as follows after assembly. Binding in the Left Middle Right needle position selector, and sometimes it won't go into Left or Right positions. Related to this, the needle bar appears to not move enough with the needle position selector, and, it is too far to the left. Walking foot doesn't "walk", instead it goes forward and backwards, I likely need to just raise the foot. In zigzag mode, machine will bind after one revolution(It doesn't complete one stitch). The machine will run indefinitely although not smoothly in straight stitch. Sorry about the mess, currently everything that should be on my sailboat is at home so it's a bit of a clutter.