Скачать с ютуб DIY Marine Diesel Engine Monitoring using SensESP/ESP32 - part 1 - Après Sail -Tech E11 в хорошем качестве

DIY Marine Diesel Engine Monitoring using SensESP/ESP32 - part 1 - Après Sail -Tech E11

In this episode we set up a ESP32-E Firebeetle 2 to be able to monitor key data from my Yanmar 3GM30 (and applicable to any engine). The device will run a program based on SensESP from the Signal K team and interface with my Openplotter system on my boat Raspberry Pi. This system could be easily extended to be NMEA 2000 for integration into an existing NMEA 2000 marine electronics system. The data that the device will provide is as follows: • Oil Pressure - requires a pressure sender and a port on the engine to connect to. • RPM - requires a pulse from the spinning engine, this is usually the 'W' terminal or Tachometer Signal wire. This could also be done using a flywheel sensor or something similar • Fuel Burn Rate - this will be calculated from the RPM • Temperature Sensors - I am using 1-Wire sensors for the following: ○ Oil Temperature ○ Aft Cabin Temperature ○ Exhaust Elbow Temperature ○ Exhaust Barrel Temperature ○ Alternator Temperature • Environmental Sensor - this device will report Temperature, Relative Humidity and Air Pressure in the engine bay SV Après is a 1996 Hunter 336 Captained and Maintained by Jason and usually sailing out of Milwaukee's South Shore Yacht Club in Lake Michigan, one of the US's Great Lakes. The filming is done via GoPro's, DJI Mavic drone and iPhone and spliced together a bit hap hazardly. Please Like and Subscribe, and drop me a comment - I love to hear from people! Here are links to the products I used - most are Amazon affiliate links, which means I get a little commission and it cost you nothing • Firebeetle 2 ESP32-E - https://www.dfrobot.com/product-2231.... • I/O Sheild for above - https://www.dfrobot.com/product-2395.... • Buck converter - https://amzn.to/3rvaHif • Waveshare BME280 environmental sensor - https://amzn.to/3QGxQcd • 1-Wire Temperature sensors - https://amzn.to/3kkkZ3f • Optocoupler (RPM) - https://amzn.to/3GuPF7m The code can be found on Github at: https://github.com/Techstyleuk/senses... Here is a link to the SensESP documentation: https://signalk.org/SensESP/pages/get... And here is a link to the SensESP project template that you would need, before replacing the main.cpp and platform.io from my repository: https://github.com/SensESP/SensESP-pr... Thanks to @boatingwiththebaileys (   / boatingwiththebaileys  ) and their Github page: https://github.com/Boatingwiththebail... the episode was filmed with 2 cameras and Snagit for screen shots. The two cameras were: • GoPro Hero 7 Black - https://amzn.to/3VlH6nZ • iPhone XR attached to a DJI OM 5 Smartphone Gimbal Stabilizer - https://amzn.to/3eqAy78