How to Change the Water Pump on a Dodge Ram 5.7L V8 Hemi скачать в хорошем качестве

How to Change the Water Pump on a Dodge Ram 5.7L V8 Hemi

How to replace the water pump on a Dodge Ram 5.7L V8. This is a 2006 1500 4wd model. Water pumps have different fail points, this can be a faulty bearing which will typically make a noise when the engine is running. This may or may not be followed by a faulty seal causing coolant to leak out the vent hole for the bearing. The seal between the block and pump casing can leak, again causing a loss of coolant. And finally is a fault impeller where it’s deteriorated, broken, or spinning on the shaft. If your coolant level is constantly dropping, there are ways to help find the leak if it’s not prominently visible. I do have videos for this, one would be using a system dye with a UV light And the other would be using a cooling system pressure tester. Here’s an example of a couple of different tools used, one is a UV light and the other is the pressure testing kit. #oemtools #emanualonline #dodgeram eManualOnline: bit.ly/3BTq3lp 20% Discount Code: 4DIYERS20 OEMTools 24609 Diagnostic Light: https://mobiledistributorsupply.com/2... OEMTOOLS 27069 Cooling System Pressure Test Pump: https://www.mobiledistributorsupply.c... OEMTools 87043 Coolant Funnel Kit :https://www.mobiledistributorsupply.c... Website: http://4diyers.com Patreon:   / 4diyers   Facebook:   / 4diyers   Twitter:   / 4diyers   Instagram:   / 4diyers   Tumblr:   / 4diyers   Pintrest:   / 4diyers   Tools/Supplies Needed: -10mm, 12mm, 15mm sockets -ratchet with extensions -large adjustable wrench -interlocking pliers -gear clamps -new upper and lower radiator hoses -coolant and distilled water -new water pump -drain pan Chapters: 00:00 Intro 00:35 How to Find a Leak 01:05 Expansion Tank and Air Intake Removal 02:11 Draining the System 02:26 Fan Shroud and Radiator Removal 04:00 Clutch Fan Removal 05:20 Water Pump Removal 06:20 Flushing the Block 07:24 Installing the New Pump 08:45 Thermostat Removal and Installation 09:38 Serpentine Belt and Pulleys 10:29 New Radiator 11:12 New Clutch Fan 13:02 Adding Coolant and Bleeding the System Thank you to all those who watch my videos and support my content. Don't forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week! © 4DIYers 2013 All Rights Reserved No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.