Red Dot Mounts | Everything You Need to Know, and More скачать в хорошем качестве

Red Dot Mounts | Everything You Need to Know, and More

00:00 - Intro 00:54 - Safety Check 01:20 - Material and Design 03:48 - How to Tell if Your Gun is Optics Ready 11:35 - Red Dot Footprints Cody tackles the toughest questions we receive about our red dot mounting plates. Our red dot mounts are made from 7075 T6 aircraft grade aluminum and are hardcoat anodized. They are machined to be a press in fit in the dovetail cuts on pistols and revolvers. Certain manufacturer's slides may require some minor fitting to properly install the mount. All of our mounts come with the required installation hardware. We now have optics ready plates for: Sig 320 Optics Ready / M17 ( we will have a plate that is specifically for this application in a few weeks) https://www.egwguns.com/pistol-and-re... Walther Q5 Match https://www.egwguns.com/pistol-and-re... HK VP9 https://www.egwguns.com/pistol-and-re... Springfield Hellcat https://www.egwguns.com/pistol-and-re... Sig P365 https://www.egwguns.com/pistol-and-re... RMR Cut Zev Slides https://www.egwguns.com/pistol-and-re... Our mounts will not work with Optics Ready models including but not limited to: Glock MOS S&W M&P Core Canik TP9SFX We recommend using a sight pusher tool to remove the old sight and install our mounting plate. Delrin or brass punches can be used, but we always recommend the sight pusher tool. Sight pusher tools are available at Brownell's, MidwayUSA, and Amazon. Most of our mounts have a slight lead on the dovetail cut and are meant to be installed from the left to the right. We recommend using a drip of blue loctite. This will act as a lubricant when installing and will also be an extra layer of protection keeping the mount in place. We recommend not over tightening the set screw. The mounting screws use a 5/64 bit and should be tightened to 15 in/lbs or whatever the recommend torque is from the manufacturer of the red dot. We offer a ton of mounts for many different rear sight cuts. If you are unsure of your rear sight cut, please give us a call and we can help guide you to choose the correct dovetail cut. We have mounting solutions for: Vortex Viper/Venom Burris Fastfire Crimson Trace CTS 1200 ADE 1200 Docter Trijicon RMR/SRO Holosun HS507C, HS407C, HS508C Leupold DeltaPoint Pro Optima Jpoint Redfield Accelerator Holosun HS407K, HS507K (when rear pins are removed from the plate) Vortex Razor C-More RTS, STS Sig Romeo 3 Max Written by Cody Peters Edited by Zachary Stubits Filmed by Zachary Stubits Produced by Cody Peters and Zachary Stubits