etrailer | Review of Bulldog Winch Dual Air Pressure Gauge and Switch - BDW55SV скачать в хорошем качестве

etrailer | Review of Bulldog Winch Dual Air Pressure Gauge and Switch - BDW55SV

Click for more info and reviews of this Bulldog Winch Air Bag Compressor Kit,Vehicle Suspension: https://www.etrailer.com/Accessories-... Check out some similar Air Bag Compressor Kit,Vehicle Suspension options: https://www.etrailer.com/dept-pg-Acce... https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-Demo-Bull... Jeff Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this dual needle 0 to 200 PSI air pressure gauge with the compressor switch. For a Bulldog winch onboard air tanks. Now, this is a dual needle in cap gauge that'll let you monitor the pressure in two onboard air tanks. Wanna zoom in just so you can see up front here. If I twist this a little bit you'll be able to see there's a bright orange needle and then a green needle right above it. This is an analog mechanical gauge which will be lighted for viewing at night. Basically when this is hooked up there'll be a light that goes around the perimeter here that'll light it up. The gauge itself you can see is a zinc plated steel construction. It's very durable and corrosion resistant. On the very back you'll notice the two brass airline connections. And all the wiring connections are marked for where they connect to. Now on front again you'll see it also has this rocker switch. And this'll let you turn on or off the on-board 12 volt Bulldog winch compressor. Also at night, what's nice is they have the on and off positions which are lighted up with LEDs. Makes it very easy to see at night what position the switch is in. Now this gauge does meet the IP68 specifications for water and dust resistance. It does come with the two 12 inch long nylon airlines. The two sets of five piece brass connection fittings. The mounting bracket you can see that the gauge is installed in is a nice steel L-shaped mounting bracket with hardware. Hardware is included. A bracket will basically install easily under your dash with the hardware. And the finish on this is a nice textured black powder coat steel which is corrosion resistant. The dimension on just the mounting bracket, the width is right at 4 inches. Total depth is right about 1 3/4 inches deep. Few specs again on the gauge, the pressure gauge maximum air pressure's 200 PSI. The dimension on just the gauge is 2 inches diameter. Total depth of about 3 inches deep. And the rocker switch, the compressor switch, the power draw on that is 20 amps at 12 volt DC. But that should do it for the review on this dual needle, 0 to 200 PSI air pressure gauge with the compressor switch for your Bulldog winch onboard air tanks..