Installing Wireways for beginners скачать в хорошем качестве

Installing Wireways for beginners

In this video I touch upon the basics of installing wire ways and show you a few of their accessories. This is basically an introduction to wireways and the installation there of it. Apprentices and beginners along with diyers can gain alot from watching this video. I will place this video under the conduit bending playlist. I also show you how to make accurate offsets with wireway elbows of 45 degrees. It's basically the same as conduit bending with a couple more added steps. Installing wireways can be intimidating but as long as you use the same steps that you would when installing conduit you should do great. Plan your route and install your supports, figure out the height you are to have the wireways. Make sure you have a clear path to run the wire ways. Also don't forget to support them every 5 feet. Also the wireways can not be filled more than 20% of there capacity. I will post a link below of the wireway fill table that you can refer to. Please consider support my channel if any of this helps you at all by sharing the video's with your friends and co-workers. Thanks again. Wire Way fill Table http://www.cadseekers.com/WirewayFill... Check out the rest of my playlists: How to Assemble and Bend w/ Hydraulic and electric benders    • Greenlee Mobile & Table bender Series   Advanced Conduit Bending Stratgies: This Playlist is more like an Advanced Bending Course. The video are pretty long and very detailed video's    • Greenlee Mobile & Table bender Series   Conduit Bending Tips and Tricks:    • Conduit Bending   Tool Unboxing and Reviews:    • Tool Unboxings   Electrical Code Calculations: This playlist is new and I currently only have one video. Check back in the near future for more video's    • Tool Unboxings   #Wireways #Holmzlaw #Conduitologist