ANSYS CFD Tutorial: Converging - Diverging Nozzle | Part 1: Sub-Sonic Flow Condition скачать в хорошем качестве

ANSYS CFD Tutorial: Converging - Diverging Nozzle | Part 1: Sub-Sonic Flow Condition

Welcome to The Engineering Guide! This is part 1 of the converging - diverging nozzle series where the various flow regimes and flow events that are expected to occur in the converging - diverging nozzle will be studied using ANSYS Fluent. In part 1, we will take a look at the sub-sonic flow conditions, the condition where the pressure at the exit of the nozzle is too high, therefore the velocity decreases as it progresses through the diverging part of the nozzle. In this video, we will see the results that are expected to be obtained, we will go through some calculation in order to determine what exit pressure will give sub-sonic flow conditions and then we will move into ANSYS Fluent to make this analysis. Thank you for watching! Hope you enjoyed! 0:00 Introduction 2:45 Calculations 13:35 Ansys Workbench 14:01 SpaceClaim Geometry Setup 21:01 Mesh Setup 31:21 Fluent - Boundary Conditions and General Simulation Setup 43:01 Running Calculation 43:37 Post Processing (Fluent) - Contours, Plots