How I Made a Rocket of my RadRover by Installing a 35 Amp Bolton Controller скачать в хорошем качестве

How I Made a Rocket of my RadRover by Installing a 35 Amp Bolton Controller

During the first three seconds of riding my brand new RadRover last year I knew it was underpowered for its class. When I discovered that Bolton Ebikes (now AREA 13 - ELECTRIC BIKES) was offering a specially made upgrade controller, I jumped at the occasion and bought one. I recently finished installing and testing it. TOOLS REQUIRED 4mm Allen wrench Philips screwdriver Flat head screwdriver Angle Philips screw driver Side cutter pliers Combination pliers A few zip ties INSTRUCTIONS: 1. Study the video on the RadRover website, then this one again. 2. Carefully read and understand the instructions that came with the controller 3. Remove battery 4. Press and hold mode button to discharge remaining power 5. Flip bike upside down 6. Remove battery cradle 7. Remove the four bolts and the two mounting brackets that hold the stock controller 8. Unplug all four visible connectors 9. Remove rubber grommet with a dull screwdriver 10. Turn handlebars to derailleur side to provide slack in harness cable 11. Push harness cable at the top of the downtube while gently pulling it out at the bottom of the frame 12. Hold the Bolton controller in place tie it temporarily near the opening at the bottom of the frame with a piece of string 13. Feed all the cables through the opening at the bottom of the frame except for the rear light cable, which you will direct upwards to the baggage rack 14. Connect all cable connectors. 15. When it comes to the harness connectors, be VERY careful to align them perfectly. You’ll need good lighting and good eyesight 16. Push the harness connection back into the downtube and pull extra cable out the top 17. Reposition the rubber grommet – if you can! 18. Using one of the mounting brackets and two bolts, secure the controller in place with the tabs at the top of the controller 19. Secure the bottom of the controller to the seat tube by passing a long tie wrap through the bottom holes in the seat tube and around the controller casing 20. Make a seam of silicone seal on each side about 5 inches long 21. Install the display as per instructions in the package.