BME280 Sensor Tutorial using Arduino скачать в хорошем качестве

BME280 Sensor Tutorial using Arduino

BME280 is a widely used temperature sensor which measures temperature, humidity, barometric pressure and altitude we are going to see how to read data from the bme280 sensor using an arduino the one which i have is the I2C version which works on 3-5v, which means we just have to use 4 wires. you will need an arduino, bme280 module, breadboard, jumper wires and a usb cable you can buy these from here: Arduino Nano: https://bit.ly/34PKuyl BME280 sensor: https://bit.ly/3nC6YeB (Amazon): Arduino Nano: https://amzn.to/30X9YbE BME280 sensor: https://amzn.to/3lB9Qqc Code: BME280: https://bit.ly/3dgor7w I2C Scanner: https://bit.ly/2SIVk3c connect 3.3v from arduino to vin of bme280 connect ground to ground connect SCL to A5 and SDA pin to A4 of arduino open the arduino ide, go to manage libraries and install the following libraries: adafruit bme280 adafruit unified sensor library then upload the code to the arduino. after uploading, open the serial monitor and you can see the readings. in case if it does not work, just check whether you have the correct I2C address for the module you can use the I2C Scanner code the check the I2C address of your sensor. hope you found the project useful. which project you would like to see using this sensor module? let me know in the comments below and thanks for watching! #BME280 #Arduino