2018 Pallet Up Cycle Challenge Dog Bowl Stand скачать в хорошем качестве

2018 Pallet Up Cycle Challenge Dog Bowl Stand

If you want to see more wood working videos click here -    • Wood Working Projects With AJ   2018 Pallet Up Cycle Challenge / Dog Bowl Stand Hey guys on this weeks edition of BS with AJ I show you how to turn an old pallet into a cool dog bowl stand! This video is also my entry into the 2018 pallet up cycle challenge held by simply wooden creations! Tools/ Material: Pallet - locally sourced Wood glue - https://amzn.to/2C4x0nc Jig Saw - https://amzn.to/2C32UQR Table Saw - https://amzn.to/2LIBsY7 Miter Saw - https://amzn.to/2MFWOuv Pneumatic Nail Gun - https://amzn.to/2BZ3kaS Air compressor - https://amzn.to/2BZ4wuS Pallet Buster - https://amzn.to/2wsWW6y The first step is to tear down your pallet and separate the good wood from the bad. This is my first time using pallet wood so i am sure there are easier ways to tear the pallets apart lol. Now that the wood is all separated I picked out 2 of the best looking boards and cut them in half, to make 2 20 inch pieces out of each of the two boards. 3 of the 4 will be the top to my dog bowl stand. I then used the table saw to trim down the sides to make them slightly straighter. Next I took the extra 20 inch piece and ripped it in half to use as the trim for the top. I then cut another board down to 10 3/4 inches and ripped it in half as well for the two short sides of the trim. I cut two more pieces to 9 inches and ripped them in half as well, these pieces will be used as the support for the top. I then clamped the 3 boards together and glued and screwed the support pieces on the back side of the top. Then it was time to add the trim. I used glue and staples to put these pieces on. Now its time to cut the holes to hold the dog bowels. I measured between the supports on the back and found the center. I then transferred those measurements to the front and drew a 5 3/4 inch circle using those marks as center points. Then I got out the jig saw to cut the holes out! Now that the top is done its time to make the legs. I cut 4 pieces 6 inches long and ripped them in half at a 45 degree angle. I flipped the pieces over to make a 90 degree angle and this is what will be our feet. I glued them together and used the staple gun to hold them in place. And that's it! I hope you enjoyed this weeks video! Be sure to like share and subscribe! Also if you have any questions or comments be sure and leave them in the comment section down below! Consider supporting BS with AJ on Patreon so we can do bigger and better projects for you guys to see! Thanks for watching and ill see you next week! We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites. Facebook -   / bswithaj   Patreon-   / bswithaj   BS with AJ YouTube Channel - https://www.youtube.com/channel/UC26T... twitter: @BSwithAJ