Mock Poll before the actual Poll | 20 steps of Mock Poll before poll | Presiding Officer' s Duty | скачать в хорошем качестве

Mock Poll before the actual Poll | 20 steps of Mock Poll before poll | Presiding Officer' s Duty |

During the day of polling, as a Presiding officer you have to start the Mock Poll 90 minutes before the scheduled time of poll. Twenty steps of Mock Poll before the Poll 1. Start Mock Poll 90 minutes before scheduled poll time, if 2 or more polling agents available. 2. Wait for 15 minutes, if one or no polling agents available. 3. Place BU & VVPAT in actual Voting Compartment. Don’t move these after mock poll. 4. Place CU on Table of 3rd Polling Officer. 5. Connect Ballot Unit cable with VVPAT and VVPAT Cable with CU. 6. Unlock Paper Roll knob of VVPAT (Working or Vertical Position). 7. Show that VVPAT is empty. 8. Switch ON the Control Unit. 9. Demonstrate no vote in Control Unit. 10. Cast at least 50 votes and record number of votes given to each (ensure votes recorded for each of the contesting candidates including NOTA). 11. Press ‘CLOSE’ button of CU. 12. Press ‘RESULT’ button of CU to ascertain mock poll result and tally with record. 13. Remove mock poll VVPAT slips from VVPAT and tally with CU result. 14. Press ‘CLEAR’ button of CU to clear mock poll result from CU and show to polling agents. 15. Stamp mock poll VVPAT slips with stamp ‘MOCK POLL SLIP’. 16. Keep mock poll VVPAT slips in Black Envelope and then seal the envelope with Pink Paper Seal. 17. Switch OFF the CU and Seal the CU with Green Paper Seal, Special Tag and Address Tag. 18. Show empty drop box of VVPAT and then seal the drop box with Address Tag. 19. Fill Mock Poll Certificate (Part-I of Presiding Officer’s report). 20. Switch ON the CU for Actual Poll and press “Total” button to confirm Zero votes. Start actual Poll. Disclaimer: This training material should not be referred as guidelines of ECI. In case of any variance in the training material, the ECI guidelines/Laws/Rules shall prevail.