Shop Made Tools | Making 60mm Open End and C Type Pin Spanners скачать в хорошем качестве

Shop Made Tools | Making 60mm Open End and C Type Pin Spanners

Multi grips, multi-grip pliers, water pump pliers, whatever you might know them as, are a common tool in tool boxes and workshops. Usually the tool of last resort, although to some DIY practitioners, they can be the tool of first resort, but they can be very handy. In this workshop, 5c collets, are used in either block holders for milling, or in the lathe for turning. To date, 5c collets, have been tighten in place using multigrips which are marking the holders. This episode is going to be about making a 60mm open end spanner to tighten the collet chuck in the lathe and a c type pin spanner to tighten the ring of the block holder. Chapters 00:00 Introduction 03:00 Making a 60mm open end spanner 07:35 Making a c type pin spanner 11:27 Different c- and pin spanner types 15:18 Finished spanners in use 16:17 Conclusion Disclaimer. This video is intended for generating ideas or entertainment purposes only. Should you choose to make or do anything as depicted on this channel you do so at your own risk. Making and the use of tools can be extremely dangerous. The equipment and methods I use may not work for you and by no means do I suggest that my methods of working are correct. Your shop safety is your responsibility, so I therefore accept NO responsibility or liability for any injuries or accidents you may have if you attempt to replicate the things that I do. #whitedoggarage #shopmade #pinspanner