etrailer | Complete Breakdown of the SeaSucker Heavy Duty Trolling Unit Rod Holder скачать в хорошем качестве

etrailer | Complete Breakdown of the SeaSucker Heavy Duty Trolling Unit Rod Holder

Click for more info and reviews of this SeaSucker Marine Fishing Rod Holders: https://www.etrailer.com/Fishing-Rod-... Check out some similar Fishing Rod Holders options: https://www.etrailer.com/dept-pg-Fish... https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-Demo-SeaS... Today we're going to take a look at the Sea Sucker Marine Vacuum Mounted Heavy-Duty Trolling Unit Fishing Rod Holder. This polished and anodized aluminum is on the super strong rod holder. It will match the look of your welded on rod holders, but the nice thing about this unit is you can take this off when you're not using it. It will attach to the surface with these two power six inch diameter vacuum mounts. It's ideal for mounting to your boat and you can mount it when and where you need it. It does attach and remove in seconds, has the nice wide vacuum mounts with the nice polished anodized aluminum holder. This part is made in the USA. I'll give you a few dimensions on this. The overall length on the holder itself, right at nine and three quarter inches. The diameter of the opening is right at two inches. When you do install this the length of it extends from the mounting surface to the furthest edge is right about five inches. It does come with this nice tube of lubricant sealant. What that's used for is maintaining your plugged up vacuum mounts. What will happen is over time you might get some dirt in these plungers and they might get a little sticky. All you have to do is pop off the plunger and there's a gasket in there. You just clean it, put some of the lubricant on it, put your plunger back in, and it'll be just as good as new. I do want to demonstrate how this installs. We're just going to pop off the covers and there's your vacuum mounts. Just going to put it up against the wall here. You can see all you have to do is push your plunger and you just push that a few times until once the orange ring there will no longer be seen. Now you'll see there's no orange showing and you'll go to the bottom one and you'll do the same thing. Just pump it until the orange disappears. Once that orange disappears, we'll do a little bit more on the top one. You can see there's your secure fit. To remove it, it's as simple as there's two tabs here. Just pull up on the tab. That will pop it loose. Same on that one, it comes right off. It's very simple installation and removal. That should do it for the review on the Sea Sucker Marine Vacuum Mounted Heavy-Duty Trolling Unit Fishing Rod Holder.