Contender Hammer Spring Install скачать в хорошем качестве

Contender Hammer Spring Install

Watch this video to learn how to install a Contender hammer spring. This is normally a very difficult task but with years of trial and error I've perfected the process as demonstrated in the video. Let me know if this helps and if you like the video be sure to let us know and subscribe. Tips: -For best quality video change your settings to HD video -Wear Glasses the spring is under a lot of tension. -A vise and jaw pads really help, I'd hate to try this without. Be sure you clamp the frame closer to the breech, lining up the sides of the frame where the sides are supported. My liners are soft enough it shouldn't be a concern but firm jaw liners could crush the sides if over tightened. -I didn't demonstrate in the video, CLEAN everything before reinstalling. I use a slight amount of gun oil on the assembly pin. -When removing the hammer, put your hand over the back of the frame the spring is under a lot of tension and when you back out the punch will go flying on you. You Need: Contender hammer spring from Bellmtcs available single, 5 pack or 25 pack. 3/32 Pin Punch 3/16 pin punch Flat blade screw driver above the width of the hammer cavity. Small jeweler type hammer Vise with jaw liners