Fitting an Anti-Roll Bar, Toyota Avensis, 2.0, D4D, T270, 2008 to 2015. скачать в хорошем качестве

Fitting an Anti-Roll Bar, Toyota Avensis, 2.0, D4D, T270, 2008 to 2015.

Here are the general steps to fit an anti-roll bar drop link on a Toyota Avensis T27 2.0 D4D: 1. Locate the anti-roll bar and the drop link. The anti-roll bar is a thick, curved bar that runs underneath the car, and the drop link is a metal bar that connects the anti-roll bar to the suspension. 2. Raise the car with a jack and secure it on jack stands. Make sure the car is on a level surface and the parking brake is engaged. 3. Remove the old drop link by unscrewing the bolts that hold it to the anti-roll bar and suspension. 4. Install the new drop link by first attaching it to the suspension and tightening the bolts to the recommended torque settings. 5. Attach the other end of the drop link to the anti-roll bar and tighten the bolts to the recommended torque settings. 6. Lower the car back to the ground and tighten the drop link bolts again to ensure they are properly tightened. 7. Check the alignment of the wheels and take the car for a test drive to ensure the new drop link is properly installed and functioning correctly. The torque settings for fitting an anti-roll bar drop link on a Toyota Avensis T27 2.0 D4D may vary depending on the specific year and model of the vehicle. However, as a general guideline, the recommended torque settings for the drop link bolts are typically in the range of 35 to 50 Nm (25 to 37 lb-ft). It is important to refer to the manufacturer's manual or technical specifications for the specific torque settings for your vehicle, as overtightening or undertightening can cause damage or failure to the components. If you do not have access to the manufacturer's manual, you can also consult with a qualified mechanic or auto parts supplier for the appropriate torque settings for your Toyota Avensis T27 2.0 D4D.