How To Configure Access Point Using The GUI/CLI Interface -Autonomous Cisco Aironet Mode - Part 02 скачать в хорошем качестве

How To Configure Access Point Using The GUI/CLI Interface -Autonomous Cisco Aironet Mode - Part 02

One device in CUWN is a lightweight AP, controlled by a Cisco Wireless Controller (WLC). Use Lightweight AP Protocol (LWAPP) to communicate between AP and WLC. This is the type of communication management and through encrypted LWAPP. Client data is sent into LWAPP frame headers for transit from the AP to the WLC. The LWAPP header contains not only data but also information about the Received Signal Strength Indicator (RSSI) and signal-to-noise ratio (SNR). WLC uses this information to improve coverage APs are of two types: Autonomous APs Lightweight APs APs have many types, each with a different feature. Among product vendors, Cisco APs are known for providing the best coverage. Let's take a look at Cisco's AP product lines in turn • Series 1130AG It works in 3 standard 802.11a/b/g and has built-in antenna Working in both autonomous and lightweight modes. And can work as a Hybrid Remote Edge AP (H-REAP) device. Complies with 802.11i/WPA2 standards. It has 32MB of RAM, 16MB of flash memory. Deployed in offices, hospitals. It has 3dB and 4.5dB gain for 2.4 and 5GHz frequency respectively The device in the video used to update the firmware is the access point AIR-AP1131G-x-K9 , for other Cisco devices, you can update the same. k9w7 – autonomous IOS k9w8 – full lightweight IOS (this is what is bundled in the WLC .aes image, and is factory installed on “mesh” APs) rcvk9w8 – lightweight recovery image – this is factory installed on lightweight APs, unless a “mesh” image is specified; it lacks radio firmware User/Pass: Cisco/Cisco Wipe your device's flash: command ( format flash:) show files in device flash command ( show flash: ) delete any file in flash command ( delete /r /f flash:yourfile ) Turn off the log in the device command ( undebug all ) ap: set IP_ADDR 10.1.16.23 ap: set NETMASK 255.255.255.0 ap: set DEFAULT_ROUTER 10.1.16.46 ap: tftp_init ap: ether_init ap: flash_init ap:tar -xtract tftp://10.1.16.46/c1130-rcvk9w8-tar.124-21a.JA2.tar flash: ... ... .... ap:boot Subcribe Us : https://www.youtube.com/c/ExploitOper... 🤝Donate us: https://www.paypal.com/paypalme/tiend... Contact : +Telegram group: https://t.me/CCNP300_410 Facebook:   / 100010133917307   Youtube:    / @exploitoperate