Eurotherm EPACK Connecting to iTools over a Network Cable скачать в хорошем качестве

Eurotherm EPACK Connecting to iTools over a Network Cable

Tutorial on how to setup communications on a Eurotherm EPACK, then how to establish a connection between EPACK and the Eurotherm iTools software. For more information on Eurotherm EPACK and iTools, follow these links: iTools: https://www.eurotherm.com/products/te... EPACK: https://www.eurotherm.com/products/po... The tutorial covers the following key steps: Initial EPACK Setup (0:20-2:11): The video begins by guiding the user through the EPACK's quick setup, focusing on configuring the communication settings, particularly setting a fixed IP address. It also advises to keep the network cable unplugged during this initial setup. Retrieving the EPACK Communications Password (2:41-3:02): After the EPACK reboots and the network cable is plugged in, the video shows how to quickly see and then retrieve the communications password by holding the "up" button on the EPACK. Connecting to iTools (3:08-5:37): The presenter demonstrates how to open iTools Engineering Studio and add the EPACK device. It includes a troubleshooting tip using the command prompt's ping function to verify network connectivity. The video then shows how to enter the communications password in iTools and set a new, permanent iTools device password. Saving the Password as a Note (5:44-6:44): A helpful hack is shown to save the iTools password as a comment block within the instrument's settings via iTools, making it accessible if the password is forgotten, without needing to perform a cold start. Disconnecting Safely (6:58-7:31): Finally, the video instructs on switching the EPACK from "access mode" back to "run mode" before safely removing it from iTools.