12) Impostazione delle altezze e delle inclinazioni delle fasce скачать в хорошем качестве

12) Impostazione delle altezze e delle inclinazioni delle fasce

Indice dei video : http://davidesora.altervista.org/vide... ENGLISH TRANSLATION of the written notes in the video, in order of appearance : 00:04 - Setting the heights and tilts of the ribs 00:12 - After about eight hours from the gluing of ribs remove clamps and proceed with the working 01:13 - Use the two appropriate wooden blocks lined with cork to tighten the form in the vice 01:28 - Cut off the excess of the ribs leaving them still abundant of about half a millimeter 02:55 - Plane gently the height of ribs bringing them at the level of the blocks without touching them 04:25 - Plane the sides of the top and back plates bringing the ribs at a constant height of about 32 mm 04:46 - Check the plane listening to the tapping sounds 04:57 - Apply pressure only on the blocks and not on the form or on the ribs, to be able to better distribute the pressure and to avoid accidentally unglue the blocks 05:20 - Making sure that the four corner blocks rest firmly on the reference plane (lower sound), leaving upper and lower blocks slightly raised (higher sound) 05:35 - Check the heights, which at this point should be about 32 mm on all blocks 05:57 - After establishing the uniform height of the ribs do the tilt only in the upper bout starting at upper corner blocks 06:16 - Mark a line at 1.5 mm from the edge of the top plate side to be used as reference for setting the tilt of the plane 06:32 - Use the plane to lower the ribs and the upper block coming on the reference line without removing it and without planing the corner blocks 06:54 - Plane the upper block coming from both sides toward the center without ever going out to the other side to avoid chipping the wood 07:09 - Refine the plane of ribs and blocks checking on the glass plate 07:46 - Finish the tilt on the sandpaper plane, using a thin cardboard to protect the parts not to be touched 08:05 - Put a mark with a pencil on the upper corner blocks, to figure out how far you take away the wood 08:21 - Refine the tilted plane also affecting the corner blocks, but not completely remove the pencil marks not to change the height of C bout 08:55 - Use a feeler gauge to check the tilt measurement (1.5 mm top plate side) 09:23 - After the tilt of the top plate side make even the one on the back plate side, lowering the height of the upper block by 0.5 mm 10:18 - Upper block 29.6 mm - corner blocks 31.8 mm - lower block 31.8 mm scarce 11:19 - http://www.davidesora.it/ Index of videos : http://davidesora.altervista.org/vide... .