Knife Making: Feather Damascus Hunter скачать в хорошем качестве

Knife Making: Feather Damascus Hunter

First hollow ground blade on the new belt grinder I made. Feather damascus made by my talented friend ‪@sperber-knives‬ make sure to check his channel out:    / @sperber-knives   Handle made of wengè, bulloak and buffalo horn provided by: https://www.etsy.com/shop/WholeEarthS... Pins are 2mm carbon fiber and fiberglass rods. Homemade black and white felt liners made like in this video: Homemade Liners:    • Felt And Resin Liner / Spacers DIY   And here are some of the videos about the tools I used: Hardening oven:    • DIY Heat Treatment Oven   Tempering oven:    • PID Controlled And Insulated Toaster Oven ...   My lovely drill press:    • ROSA Drill Press Restoration | The Best It...   I listed some of the stuff I use for my projects in this amazon storefront: https://www.amazon.com/shop/blackbear... It's affiliate marketing, so if you order something from here you'll help the channel for free! Thank you! Index of operation and materials: 0:24 Quick etch in ferric chloride to see the pattern 0:40 Knife sketch used as stencil 0:54 Cut excess material with metal cutting bandsaw 1:08 Grind profile with 2x72 belt grinder 1:30 Inside radius refined with die grinder and stone grinding bit 1:50 Cente punch pin and weight reduction holes 2:00 Drill holels, 2mm for the pins 2:20 Blate tapered from ricasso to tip with 2x150 belt grinder 2:37 Notch filed in with round file 2:50 Hardening: heat to 795°c, hold for 8min and quench in 70°c oil 3:17 Tempering: heat to 200°c and hold for 2hrs (final hardness between 50 and 55 Rockwell) 3:30 Hollow grind bevels with 2x150 belt grinder contact wheel 4:00 Three 15min cycles in ferric chloride with light scrub in between 4:12 Istant coffee etch to darken more the high carbon steel 4:40 Handle stack glued with 5min epoxy 5:18 Black felt liner glued with 5min epoxy 5:52 Temporarly hold tang to scales with ca glue and masking tape 6:03 Drill pin holes in one scale 6:20 Match drill the other scale again with ca glue and masking tape trick 7:04 Finishing top of the handle as it can't be accessed later 7:30 Notch for loop ground with dremel 7:40 Final glueup with 90min epoxy 8:49 Handle squared up with flat platen 8:59 And sculpted with contact wheel 9:22 Hand sand up to 400grit 9:43 White mineral oil for finish 9:55 Short secondary bevel ground with MadEdge: https://www.madedge.net/ 10:20 Strop on leather with fine polishing compound Thanks a lot for watching, I hope you liked the video! Suggestions and comments are welcome. Leave a like and share to anyone who might be interested! ★Patreon★   / blackbeardprojects   ★Website★ http://blackbeardproject.com/ ★Follow me★ Facebook ►   / blackbeardprojects   Twitter ►   / blackbeardproje   Instagram ►   / black_beard_projects