DTC Nissan P1132 Short Explanation скачать в хорошем качестве

DTC Nissan P1132 Short Explanation

The video focuses on the basic Nissan specific diagnostic error code. Contents: 0:21 Basic DTC analysis according to OBD2 protocol standard. 1:48 Insight into programming an explanation of what a bit is and how a byte is formed decoding the Error Code to the base programming 2:58 A diagnostically understandable description of the Diagnostic Trouble Code 3:05 Basic error definition Possible causes or errors of the car and its parts describing the mentioned error We will continue to work on improving the content. Our efforts at Maxidot s.r.o.the video content gets better. #maxidot #dtc #howto #diagnostictroublecode #nissan Make: Nissan Code: P1132 Definition: Right Rear Wheel Speed Sensor Signal Invalid or No Signal Description: Signal Missing,Speed Too Low Vehicle Speed > = 10 km or h (6.2mph) (Drive-Off Detection) A failure is detected at all wheel speed sensors with a speed of lower than 2 km or h if the speed of the fastest wheel (Vamx) is continuously above 10 km or h longer than 180 s.- The monitoring function is always started if Vmax drops below 10 km or h or if Vmin reaches 2 km or h (1.2mph) .Vehicle Speed > = 15 km or h (9.3mph) (Drive-Off Detection) A failure is detected at all wheel speed sensors with a speed of lower than 6 in case of the following condition.1. Immediately if the speed of a non-driven wheel reaches 15km or h.2. Immediately if the speed of a fastest wheel(Vmax) reaches 15km or h without detected overspinning.3. The speed of a fastest wheel(Vmax) is continuously above 15km or h with overspinning detected by deceleration phaes.4. The speed of a fastest wheel(Vmax) is continuously above 15km or h with detected overspinning.- The monitoring function is always started if Vmax drops below 7 km or h (4.3mph) and Vref drops below 6 km or h (3.7mph) ,and it is stopped if Vref reaches 6 km or h.The entry of the monitoring function may be delayed up to 5s if Vmin >7 km or h has been detected before.The monitoring function is stopped if the fastest wheel reaches 13 km or h (8.1mph) and no gaspedalactivity is recognized.Vehicle Speed > = 15 km or h (Extended Wheel Speed Comparison) A failure is detected at all wheel speed sensors satisfied with the following conditions for more than 120s.1. Vmax > = 15km or h (9.3mph) and Vmin = (0.4Vmax) 2. Vmax > = 40km or h (24.9mph) and Vmin = (0.6Vmax) Control Cycle Too Long A failure is detected if the duration of permanent pressure reduction or pressure holding phases exceeds for 28s. Cause: Improper installation of wheel speed sensorAbnormal Rotor and wheel bearingFaulty Wheel speed sensor(FL,FR,RL,RR)Faulty HECU