How to set up and mix a floor monitor on the Behringer X32 скачать в хорошем качестве

How to set up and mix a floor monitor on the Behringer X32

One of the most common questions I receive with the Behringer X32 is how to set up a floor monitor or a floor wedge. In this video I walk you through from the beginning of how to: Setup your Behringer X32 for routing for monitors How to use sends on fader to mix monitors How to put reverb into the monitor There seems to be a bit of confusion about when I am setting the post-fader tap point later in the video, this is post-fader so that you have volume control of the floor monitor with the mixbus master fader. Setting this tap-point does not make your mixbus a post-fader setup, this was set when we set up our mixbusses earlier in the video. So don't skip over the part where I talk about the setup for the Mixbusses around the 01:40 mark. Learn more about the X32 Fundamentals Course at https://course.drewbrashler.com. Link to the blog post: https://drewbrashler.com/2022/intro-t... Products shown in this video: Behringer X32 Full Size - https://amzn.to/3KQIrgC Chapters: 00:00 Intro 00:52 X32 Setup for the Floor Monitor 01:40 Quick Setup of Mixbusses for Monitors 03:40 Assign Mixbus 1 to a Floor Monitor 04:47 Routing Monitor 1 to XLR Outputs 05:22 Routing Monitor 1 to Aux Outputs 06:14 Sends on Fader - Mixing to the Floor Monitor 07:24 Mixing Monitors Using Sends section of X32 09:09 TIP! Use Solo along with Sends on Fader 09:50 How to add reverb to the monitor 12:12 Conclusion