How to apply Nano4 Glass Ceramic protective coating on your glass shower screen скачать в хорошем качестве

How to apply Nano4 Glass Ceramic protective coating on your glass shower screen

NANO4 GLASS CERAMIC PROTECTIVE COATING Application process with Tips & Tricks • Before you apply, make sure the surface is clean, dry and free of residues. • Do not dilute Nano4-Glass Ceramic protective coating with water as it is not required. • Once the surface is clean and dry, apply Nano4-Preclean product by spraying 15cm away (on a small area 30cm x 30cm at a time) and rub the surface with a micro fibre cloth in a circular motion. Nano4-Preclean is used to remove any previous chemical residues to ensure the glossy surface is clean. • Now apply Nano4-Glass Ceramic protective coating by spraying 15cm away (on a small area 30cm x 30cm at a time) and rub on the target surface with a new micro fibre cloth in a circular motion. Once sprayed, make sure you wipe it straight away and don’t let it dry up. Give it a good polish and continue until complete. On the bottom half inside of the shower screen, you may apply a second coat if you want a professional result and just in case you missed a spot. A second coat can be apply straight away after the first coat. • Allow to fully cure for 12-24hours. Nano4-Glass Ceramic protective coating offers a long life protection of up to 5 years for new glass surface and when applied correctly according to instructions and maintained according to Nano4Life’s maintenance guide. However, you may need to re-apply earlier depending on the harshness of the environment, the usage and for optimum results. TIPS & TRICKS • If the surface is dirty, make sure you clean it first as you normally do your cleaning. Once it’s clean and dry then start applying the Nano4-Preclean & follow the rest of the instructions. • Apply on a small section at a time so the liquid doesn’t dry up before you finish rubbing over the surface • Once you rub over the surface, look on an angle and if you see streak marks, rub over it again until dry • Use a new cloth when applying Nano4-Pre Clean and Nano4-Glass Ceramic • Before you apply Nano4-Glass Ceramic, spray a bit of Nano4-Glass Ceramic on the micro fibre cloth. Follow the instruction of how to apply Nano4-Glass Ceramic accordingly. • If you’re unsure please contact us for help. --------------------------------------------------------------------------------------------------------- General Rules for all glass surface maintenance • Clean as necessary using a sponge with warm water mix with mild detergent and give it a quick wipe down, then rinse with water. Use a squeegee or a plush microfiber cloth to wipe dry. Click below for more info; WWW.NANO4LIFE.COM.AU