Drip Fed Waste Oil Burner 360c and above скачать в хорошем качестве

Drip Fed Waste Oil Burner 360c and above

This is my video for the construction of a home made Drip Feed Oil Burner. This step by step guide will show you exactly how to construct your own Oil Burner. This is ideal for use outdoors, in sheds or garages etc. Please visit: http://www.instructables.com/id/Purgi... For instructions on how to purge a gas cylinder. The fan I used was salvaged from an end-of-life combi-boiler which can often be picked up for free in the UK. To start the burn process I use a small amount of paper soaked in diesel, dropped into the burn chamber (inner gas bottle), then ignited by flame. Once the burn chamber is hot, the oil feed can be opened to drip feed into the scaffold pole. Finally switch on the fan & if successful the noise will confirm you are burning the oil as it enters the burn chamber. If the fan blows the flame out just start again & allow a little more time for the burn chamber to heat up before switching on the fan. Once it is running correctly there should be no smoke at all exiting the flue. A small tweak of the oil tap should produce instant sound & heat changes. Once you are proficient in setting the burner going it can be done in less than 20 seconds with only a very small amount of smoke being produced.