How to programe a 4 flap flying wing, Spektrum DX9 скачать в хорошем качестве

How to programe a 4 flap flying wing, Spektrum DX9

How to Program a flying wing glider with 4 flap wing, Set it up as a normal glider with 2 ailerons and V tail. Outer flaps are ailerons and inner flaps are the elevator/rudder Then a mix: Aileron- rudder, to get the elevators to go as ailerons. Then a mix: elevator- L aileron, to get the ailerons to go as elevator, and set the trim to active. And then set the Dual rate for the rudder to % to disable the rudder stick. At camber system you adjust the aileron up in Crowbrake and after this go to preset Mix: Flap – elevator, here you set the elevator down in the Crow brake, after this you go to camber system and just the offset so that both aileron and elevator start to move at the same time when using the throttle stick. You can also set the crowbrake on a switch and set it up as flight mode in the Camber preset, if you will use the throttle stick on a motor. Program DX G2 planes as step by step in a easy way 1. Select plane type: Chose always glider if you want to use spoilerons or flaps 2. Select wing type. Also motor if it’s a motor plane or motor glider. If it is a flying wing then use motor plane. 3. Set trim set up to FL mode 4. Put in the servo plugs in the receiver. Use the monitor to see this…. 5. Set the right directions and sub trim the servos. 6. Set the travel for the servos 7. Set the ailerons differential, not too much because this can be a problem when using spoilerons and flaps 8. Dual rate and expo, 50% on ailerons and 40% on elevator and rudder is a good start. 9. Set F mode switch 1, 2, 3, maybe more if you want to use more than 3 flight modes on a glider 10. Camber preset: Motor plane/Glider, here you adjust: Motor plane: Flaps up/ take off flaps/ landing flaps and elevator compensation and how fast the flaps move. Glider:Flight modes as Thermal /cruise/speed and how fast it changes 11. Camber system: Glider, here you adjust landing flaps/ crow brake and which switch or stick you will use for it. (In crow brake not more up aileron when using the crowbrake that when using the ailerons the aileron that going down must go down to neutral, in this way you still have good aileron control. 12. MIX: Flaps- elevator, here you adjust the elevator compensation when using the landing flaps (Camber system) and adjust the offset so that the elevator start moving when the flaps is moving when using the throttle stick to control it. 2 mm down when using the flaps is a good starting point. 13. Mix: Ailerons- flaps, here you adjust all span ailerons 14. Elevator- flaps, here you adjust snap flaps 15. Aileron –rudder, here you adjust as described 16. Set up the spoken Flight modes and switch change sounds 17. Set up telemetry in auto config. 18. Motor planes with flaps: you can go to elevator dual rate and set the switch to flt mode/ flaps switch and then set it so you still have full up elevator movement, when using the flaps and have set down elevator compensation, inthis way you still have enough up elevator to pull up in the landing when using the flaps 19. Set the timer