PORTER II Fan belt installation of Hyundai truck D4CB скачать в хорошем качестве

PORTER II Fan belt installation of Hyundai truck D4CB

PORTER II - Hyundai Fan belt installation of Hyundai truck #D4CB #bilt porter2 Here are the general steps for installing a fan belt on a Hyundai Porter II truck with a D4CB engine: 1. Locate the tensioner pulley: The tensioner pulley is typically located near the top of the engine and is used to adjust the tension of the fan belt. 2. Loosen the tensioner pulley: Use a socket wrench or belt tensioner tool to rotate the tensioner pulley and release tension on the old fan belt. Once the tension is released, the old belt can be removed. 3. Install the new belt: Route the new fan belt around the pulleys on the engine, making sure to follow the correct routing diagram for your specific vehicle. The correct routing diagram can typically be found in the owner's manual or a service manual. 4. Apply tension: Use a socket wrench or belt tensioner tool to rotate the tensioner pulley and apply tension to the new fan belt. Make sure the belt is properly tensioned and aligned with all the pulleys. 5. Check tension and alignment: After installing the new fan belt and applying tension, check the tension and alignment of the belt. The belt should be snug but not too tight, and should run smoothly around all the pulleys without slipping or jumping. 6. Reassemble any removed components: Once the new fan belt is properly installed and tensioned, reassemble any components that were removed to access the belt. It is important to use the correct size and type of fan belt for your specific vehicle, as using the wrong belt can cause engine damage or performance issues. If you are unsure about how to install a fan belt on your Hyundai Porter II truck, it is recommended to refer to the owner's manual or a service manual, or consult a qualified mechanic.