1959 CATERPILLAR D7C For Sale скачать в хорошем качестве

1959 CATERPILLAR D7C For Sale

https://www.forestrytrader.com/listin... 1959 Caterpillar D7C Cable Crawler Dozer Serial Number: 17A15702 (derived from original damaged factory identification plate) TMJ Auctions is pleased to present this classic 1959 Caterpillar D7C cable crawler tractor, configured with a 10-foot straight cable blade, swinging drawbar, and traditional Caterpillar lever-and-pedal control layout. This machine represents a properly documented, historically correct 17A-series D7C in industrial configuration and is well suited for ranch use, forestry, restoration, or collector ownership. Buyers seeking a classic mechanical D7 with blade and traditional controls will appreciate the transparency and completeness of this listing. Engine Manufacturer: Caterpillar Model: D339 Arrangement: Inline 6-cylinder diesel Aspiration: Naturally aspirated Emissions Tier: Tier 0 (pre-emissions) Caterpillar D339 inline 6-cylinder diesel engine, naturally aspirated, Tier 0 (pre-emissions). Starting System Starting system is pony motor equipped. The pony motor does not run. The seller, who has owned the machine for over 15 years, has always pull-started the tractor, typically requiring approximately 20 feet of pulling to start. Once started, the main engine runs and operates. Hours Hours: Unknown. The hour meter is inoperative. The current owner estimates approximately 1,000 hours of use during their ownership. Transmission & Drivetrain Manual constant-mesh transmission 5 forward / 4 reverse speeds Maximum travel speed approximately 7.5 mph Mechanical steering clutches and brakes No traction control No differential steering Undercarriage Dry-type (non-sealed) track chain system Rigid track frames Standard duty configuration 22" single grouser track pads Segmented center undercarriage guards Undercarriage condition reported as #2. Blade & Attachments 10' straight cable-controlled dozer blade Cable lift and angle No hydraulic tilt Approximate blade capacity: 175–200 cubic feet Swinging drawbar All blade control cables have been replaced and are new. Protection Equipment Engine / radiator protection sweeps Radiator and engine debris screens Undercarriage and powertrain guards Controls Traditional Caterpillar lever-and-pedal control configuration Steering via hand levers and foot brake pedals Performance Approximate drawbar pull: 44,000–46,000 lb Equipped with rear counterweight Fuel & Weight Approximate 65-gallon diesel fuel capacity Operating weight approximately 45,000–46,000 lb, depending on configuration Transport Dimensions (Approximate) Length: 18'6" Width: 108" (outside tracks) Height: 9'8" Operating Weight: 45,000–46,000 lb Operational Notes Hour meter is inoperative; total hours are unknown Current owner estimates approximately 1,000 hours of use during ownership Pony motor is inoperative Tractor is routinely pull-started by seller (approx. 20 ft pull) Main engine runs and operates once started Machine moves and operates No operational load testing beyond basic movement and function verification Important Notice to Bidders By placing a bid on this item through TMJ Auctions, you are agreeing to all Terms and Conditions as outlined by TMJ Auctions and General Terms All items are sold AS-IS, WHERE-IS, with no warranties expressed or implied. Item descriptions are based on information provided by the seller and visual inspection of the item. TMJ Auctions strongly recommends reviewing all photos and videos for the most accurate representation of the item’s condition. In-person inspections are encouraged and available by appointment only. Choosing not to inspect prior to bidding is entirely at the bidder's discretion. ALL SALES ARE FINAL. No returns, refunds, or exchanges will be accepted. Post-Auction Process The winning bidder will receive an invoice and payment instructions via the email address registered with AuctionTime after the auction concludes. Once payment is received and verified (typically within 1 business day of submission), a second email will be sent containing: A Paid-in-Full Receipt / Bill of Sale Buyer Instructions for coordinating item pickup Communication & Invoicing For questions related to invoicing or post-sale procedures, please email: TMJ.HQ@ (The appropriate representative will respond within 24 hours.) Financing Options TMJ Auctions has partnered with CURRENCY Finance as our preferred financing provider. To get pre-qualified with a soft credit check and receive your free loan quote, visit our website and click the “Financing” tab on the homepage. TMJ Auctions does not participate in the financing application or approval process.