Fanatec Pedal Inversion - Hints & tips to DIY a PVC Sim driving rig, 4 of 5 скачать в хорошем качестве

Fanatec Pedal Inversion - Hints & tips to DIY a PVC Sim driving rig, 4 of 5

Note I have reverted back to floor mounted factory mount as I could not make pedals feel any better (or even as good as) the factory mount. See next vid Overall this changes the way the pedals feel so it is very important to get all angles right. Offset of parallel tubes - lower is 50mm (does not include length inside T -pieces) upper is 105mm. Angle of Pedals. Pedal face of accelerator is 60 degrees facing you. This could be increased ~70 deg for easier travel. If you do make the pedal face higher, this will only work ergonomically if your seating setup is more street car like, i.e. your floor is lower than seat (mine was 20cm) Rear mount of accelerator pedal is 72degrees. As above, this could be more vertical. Other pedals are mounted at 63degrees Use 6mm metric bolts, not imperial as heads wont fit slots in pedals. Or grind bolt heads to suit. Recommend looking at the Fanatec pedal inversion kit, not to buy because its poor value, but to copy the angles.