Clarisonic Mia Battery Replacement Part 3: Cutting with the Dremel Tool скачать в хорошем качестве

Clarisonic Mia Battery Replacement Part 3: Cutting with the Dremel Tool

This is part 3 of the tutorial showing the easiest way to cut open the Mia (IMO). It's far less effort than using a knife from Part1 video. However Dremel Tool and Cutting Wheel #409 is required. Please like the video if this helps. On this 2nd unit, I used Dremel Tool, clean up the edge, cut out the battery connecting plates using Dremel, solder the new Eneloop AA, then apply Hot Glue inside the unit to create padding before closing the gap. After putting the case back together, I apply Hot Glue to seal it - Make sure you insert a lot of glue thru the gap. Then I tape the edge with Silicone self-fusing tape. Charge it up and run. Done!