0.28 Ohm | Conductor Coil aka The Gen-a-drip Coil Tutorial скачать в хорошем качестве

0.28 Ohm | Conductor Coil aka The Gen-a-drip Coil Tutorial

This is a tutorial for an awesome flavor chucking build that I've been working on for the last few weeks. It really kick starts your e-liquid if you've been suffering from Vaper's Tongue. Make sure to cut the Stainless steel mesh as evenly as possible to avoid ripping your fingers apart :) I'm using a single piece of 24 gauge kanthal, a 2mm wide piece of 325 stainless steel mesh and 0.8 x 0.1mm kanthal ribbon wire to hold everything in place. You can also use a tiger coil or twisted wire to wrap the mesh and ribbon around. It then becomes a "Twisted Conductor" or a "Tiger Conductor Coil". *Below you will find a link for a 33cm x 33cm (12x12") sheet of stainless steel mess for a low price: http://www.happyvaper.com/325_Mesh_T3... *Also a coupon code for 10% off on it: HV-MDT2MY *Please like, comment and subscribe:    / maestrovapes   I did go off camera slightly at the end of the wrapping but by that point I'm just repeating the process. It should not affect the tutorial, however, my apologies.