AirWeights Vacuum Pump Setup Instructions - How to install your pump fittings and air lines скачать в хорошем качестве

AirWeights Vacuum Pump Setup Instructions - How to install your pump fittings and air lines

This video demonstrates setup for an AirWeights Vacuum pump. Please follow the instructions below: Vacuum Pump Setup: 1. Install Rubber Feet- These feet dampen the vibration. Install hand-tight only. 2. Install Exhaust Muffler onto exhaust port- Thread into place, hand-tight only. 3. Install Intake Components onto intake port: Apply PTFE tape on all male threads. Apply liberally so that threads can be clocked to desired position in each connection. Install Intake Filter to pump intake using male-male threaded adapter. Note the direction of the arrow on the filter inlet; this should point towards the pump.  Filter canister may be removed for easier installation. Install T-adapter (male/female/female) Install Vacuum Gauge. Be sure to end rotation at a viewable position. Install push-to-connect fitting onto end of T-adapter. 4. Install a push-to-connect fitting onto one of the threaded ports on the side of your AirWeights table. There are ports on all sides for easy access depending on your specific setup. 5. Install the air line between the pump and the AirWeights table. Both sides utilize push-to-connect. Simply push the end of the air line firmly into the fitting to seal. To release the fitting, push the plastic collar towards the metal flange while pulling the air line out. For additional instructional content, or to contact AirWeights for questions, visit www.airweights.com