CO2 Laser Air Assist Setup скачать в хорошем качестве

CO2 Laser Air Assist Setup

This video is how to install an air assist based on my setup. I have a list of the items used on my website. www.oeadesignworks.com/airassist This works for OMTech and Monport Lasers EDIT: AT 8:16 THAT IS NOT A DIODE, THAT IS A RESISTOR. I WILL LOOK INTO MAKING ANOTHER VIDEO TO INSTALL A DIODE. THE DIODE SHOULD ONLY HAVE ONE STRIPE ON IT AND WILL BE CONNECTED BETWEEN THE TWO POWER TERMINALS. THE END OF THE DIODE WITH THE STRIPE WILL CONNECT TO THE 24V SIDE, THE OTHER END WILL CONNECT TO THE TERMINAL THAT IS WIRED TO THE WIND OR STATUS TERMINALS ON YOUR CONTROLLER Watch this video to setup the controller to work with this air assist setup    • Ruida Controller Air Assist Setup   My installation allows for air to be on from the compressor all the time not only running when the laser is running. Meaning you are not blowing compressed air the entire time your machine is on, but instead only when the laser is on. In doing so I still am able to have two different air flows for cut layers vs engrave layers. This is all controlled via turning the air assist on or off for a particular layer in Lightburn OMTech Websites OMTech US Site - Save 5% on entire cart & free shipping use code ---- oeadesign5off https://omtechlaser.com/oeadesign OMTech Canadian Site - Save 5% on entire cart & free shipping use code ---- oeadesign5off https://ca.omtechlaser.com?sca_ref=26... OMTech UK Site - Save 5% on entire cart & free shipping use code ---- oeadesign5off https://omtechlaser.uk?sca_ref=264326... My Website - Navigate to OMTech Laser section at the top (feel free to check out my site too) https://www.oeadesignworks.com/omtech... Rotoboss Website, use my affiliate link below and Save 5% on entire cart use code - oeadesign https://rotaryattachments.com/?wpam_i... SpeTools Website Save 10% on entire cart use code ---- oeadesign https://spetools.com/?ref=OEADESIGN Discount Code "OEADESIGN" to save 10% off your entire order