How to Build Clones | DIY Guitar Pedals скачать в хорошем качестве

How to Build Clones | DIY Guitar Pedals

Hey all! This is a step-by-step guide to making a guitar pedal clone using a purchased PCB. I go through the best sequence in populating the board, how to complete your offboard wiring, etc. I even touch on how to make an optocoupler. I use a PedalPCB Delegate Compressor as the example, but these steps can be used for all PCB builds. Hope you find it useful! 02:40 - Workstation and parts 04:25 - Soldering resistors 05:35 - Soldering diodes 06:05 - Soldering IC sockets 07:08 - Soldering capacitors 08:00 - Soldering Transistors 08:27 - Soldering/ Building the LDR and Diode (Optocoupler) 11:43 - Soldering power (On/Off) Diode 12:28 - Soldering potentiometers 15:50 - Affixing the LED Bezel 16:20 - Wiring the 3PDT Switch 17:00 - Connecting the main board to the switch board 20:25 - Installing the DC jack 22:42 - Installing the audio jacks 23:49 - Socketing the ICs 24:20 - Adding the control knobs 25:30 - Closing the case 25:38 - A quick sanity test Check out how I add graphics here:    • Enclosure Graphics | DIY Guitar Pedals   #pougnetpedals #diyguitarpedals